Ricoh CL3000 Printer User Manual


 
1394 Interface Unit Type 4510
21
1
G
GG
G
Fasten the 1394 Interface Unit on
the controller board using the
screws that you removed in step
E
EE
E
.
H
HH
H
Align the controller board to the
top and bottom rails, and then
push in slowly until it stops.
Note
When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
option.
Important
The printer may not work prop-
erly if the controller board is not
set correctly.
I
II
I
Fasten the controller board to the
printer with the two screws that
you removed in step
C
CC
C
.
Note
After finishing installation, you
can check whether the 1394 In-
terface Unit is installed proper-
ly. Print the configuration page
from the "List/Test Print"
menu. If it is installed properly,
you will see "IEEE1394" for
"Controller Option".
If the 1394 Interface Unit is not
installed properly, reinstall it
from step
B
. If you cannot in-
stall it properly even after at-
tempting reinstallation, contact
your sales or service representa-
tive.
Reference
See "Making Printer Settings
with the Control Panel" in the
Administrator Reference for
printing the configuration page.
ZHBPB060E
ZHBP070E
ZHBP010E
AresPGBOptionSetup-F_FM.book Page 21 Monday, July 29, 2002 1:12 PM