Filter
Top Products
Operating Instructions Administrator Reference
189
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
*1
Available when the optional 1394 Interface Unit is installed.
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use remote access. If this
was a mistake, you can use the control panel to allow access by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using ip1394, lpr, ftp, rsh, diprint,
web, snmp and ipp.
Protocol
appletalk
tcpip
netware
netbeui
scsiprint
*1
ip1394
*1
lpr
ftp
rsh
diprint
web
snmp
ipp
“up” means active and “down” means inac-
tive.