Filter
Top Products
Troubleshooting
56
5
Hardware Problem
Option RAM
There is a problem with the
optional Memory Unit.
Remove and reinstall the op-
tional Memory Unit. If the
message appears again, con-
tact your sales or service rep-
resentative.
See the Option Setup Guide.
Hardware Problem
Parallel I/F
There is a problem with the
parallel interface.
If you use the parallel inter-
face, replace the interface ca-
ble that caused the error. If the
message appears again, con-
tact your sales or service rep-
resentative.
Hardware Problem
USB
There is a problem related to
the Universal Serial Bus Con-
nection and Hardware.
Remove and reinstall the USB
board. If the message appears
again, contact your sales or
service representative.
Invalid Password
Try Again
The entered password is not
correct.
Enter the correct password.
Load Correct
Size Paper
/Press #
To Continue
The paper size set in the indi-
cated tray differs from the set-
ting made.
Load paper of the selected size
in the tray, and then press the
{
{{
{Enter #}
}}
} key to resume print-
ing. If you want to ignore the
message and continue print-
ing, press the {
{{
{Enter #}
}}
} key.
Load Paper
/Paper Size:
Paper Type
The paper size set in the indi-
cated tray differs from the set-
ting made.
Load paper of the selected size
in the tray, and then change
the paper size setting with the
control panel.
Or press the {
{{
{Form Feed}
}}
} key
several times until the tray
with the desired paper type
and paper size appears on the
panel display.
Or press the {
{{
{Job Reset}
}}
} key to
cancel the print job.
Load paper of the selected
type in the tray, and then
change the paper size setting
with the control panel.
Or press the {
{{
{Form Feed}
}}
} key
several times until the tray
with the desired paper type
and paper size appears on the
panel display.
Or press the {
{{
{Job Reset}
}}
} key to
cancel the print job.
Messages/Second messages Description Solution
AresPGBMaintGuide-F_FM.book Page 56 Friday, July 26, 2002 5:17 PM