Filter
Top Products
User Account Enhance Unit Type B
39
1
D
DD
D
While holding the handle, pull
out the controller board slowly.
The User Account Enhance Unit is
to be installed to the position
shown in the illustration.
E
EE
E
Set the User Account Enhance
Unit on the controller board in the
direction shown in the illustra-
tion.
Confirm that the User Account En-
hance Unit is firmly connected to
the controller board.
F
FF
F
Align the screw hole of the User
Account Enhance Unit and the
controller board, and then fasten
the User Account Enhance Unit
on the controller board using a
supplied screw.
G
GG
G
Align the controller board to the
top and bottom rails, and then
push in slowly until it stops.
Note
❒ When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
option.
Important
❒ The printer may not work prop-
erly if the controller board is not
set properly.
ZHBP020E
ZHBP130E
ZHBP140E
ZHBP150E
ZHBP070E
AresPGBOptionSetup-F_FM.book Page 39 Monday, July 29, 2002 1:12 PM