Filter
Top Products
Operating Instructions Administrator Reference
200
ssid ID value You can set for SSID in infrastructure mode.
The characters that can be used are ASCII 0x20-0x7e
(32 bytes).
A SSID value is set automatically to the nearest access
point if the setting has not been made.
If the setting has not been made for ad hoc mode, the
same value as for infrastructure mode or an "ASSID"
value is set automatically if the setting has not been
made.
channel frequency channel no. You can set the channel.
You can specify from following channel.
• Metric Version :1-13
• Inch Version :1-11
Set the same channel for all the machines you are using.
enc [on|off] You can enable or disable the WEP function. To enable
the WEP function, specify [on]; to disable it, specify
[off].
To start the WEP function, enter the correct WEP key.
key [key value] With a 64-bit WEP, you can use 10 digit hexadecimal.
With a 128-bit WEP, you can use 26 digit hexadecimal.
To use this function, set the same WEP key for all the
ports that transmit to each other.
Parameter Value to be configured