Filter
Top Products
52
Operating Instructions Administrator Reference
3. Windows NT 4.0 Print Server Configuration
To use a printer connected to the Ethernet interface, select "SmartNetMonitor" or "LPR Port" when in-
stalling the printer driver.
• SmartNetMonitor
See p.52 “Configuring the Protocols” and p.56 “Installing Software” and p.57 “Installing the PCL
5c or RPCS Printer Driver” or p.62 “Installing the PostScript Printer Driver”.
• LPR Port
See p.52 “Configuring the Protocols” and p.57 “Installing the PCL 5c or RPCS Printer Driver” or
p.62 “Installing the PostScript Printer Driver”.
Note
❒ If you want to use “LPR Port", "Microsoft TCP/ IP Printing" must be installed.
Configuring the Protocols
Configuring TCP/IP and IPP for Printing
Follow these instructions to configure the Network Interface Board and Windows NT to use the TCP/IP
protocol and IPP.
Configuring the printer
Configure the printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is active.)
• Assign an IP address and make other settings required for using the TCP/IP protocol.