Filter
Top Products
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i 183 Revision 1.4 (08-19-08)
DATASHEET
14.2.2.2 Transmit Configuration Register (TX_CFG)
This register controls the Host MAC transmit functions.
Offset: 070h Size: 32 bits
BITS DESCRIPTION TYPE DEFAULT
31:16 RESERVED RO -
15 Force TX Status Discard (TXS_DUMP)
When a 1 is written to this bit, the TX Status FIFO is cleared of all pending
status DWORD’s and the TX status pointers are cleared to zero.
WO
SC
0b
14
Force TX Data Discard (TXD_DUMP)
When a 1 is written to this bit, the TX Data FIFO is cleared of all pending
data and the TX data pointers are cleared to zero.
WO
SC
0b
13:3
RESERVED RO -
2 TX Status Allow Overrun (TXSAO)
When this bit is cleared, Host MAC data transmission is suspended if the
TX Status FIFO becomes full. Setting this bit high allows the transmitter to
continue operation with a full TX Status FIFO.
Note: This bit does not affect the operation of the TX Status FIFO Full
Interrupt (TSFF).
R/W 0b
1
Transmitter Enable (TX_ON)
When this bit is set, the Host MAC transmitter is enabled. Any data in the
TX Data FIFO will be sent. This bit is cleared automatically when the
STOP_TX bit is set and the transmitter is halted.
R/W 0b
0
Stop Transmitter (STOP_TX)
When this bit is set, the Host MAC transmitter will finish the current frame,
and will then stop transmitting. When the transmitter has stopped this bit will
clear. All writes to this bit are ignored while this bit is high.
R/W
SC
0b