Filter
Top Products
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i 285 Revision 1.4 (08-19-08)
DATASHEET
14.3.11 Host MAC Wake-up Frame Filter Register (HMAC_WUFF)
This write-only register is used to configure the wake-up frame filter. Refer to Section 9.5, "Wake-up
Frame Detection," on page 117 for additional information.
Offset: Bh Size: 32 bits
BITS DESCRIPTION TYPE DEFAULT
31:0 Wake-Up Frame Filter (WFF)
The Wake-up frame filter is configured through this register using an
indexing mechanism. After power-on reset, digital reset, or soft reset, the
Host MAC loads the first value written to this location to the first DWORD in
the Wake-up frame filter (filter 0 byte mask). The second value written to this
location is loaded to the second DWORD in the wake-up frame filter (filter 1
byte mask) and so on. Once all eight DWORD’s have been written, the
internal pointer will once again point to the first entry and the filter entries
can be modified in the same manner.
Note: This is a write-only register.
WO -