Filter
Top Products
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
Revision 1.4 (08-19-08) 250 SMSC LAN9311/LAN9311i
DATASHEET
Note 14.17 The reserved bits 31-16 are used to pad the register to 32-bits so that each register is on
a DWORD boundary. When accessed serially (through the MII management protocol), the
register is 16-bits wide.
Note 14.18 The Virtual PHY supports 100BASE-X (half and full duplex) and 10BASE-T (half and full
duplex) only. All other modes will always return as 0 (unable to perform).
Note 14.19 The Virtual PHY does not support Register 15 or 1000 Mb/s operation. Thus this bit is
always returned as 0.
Note 14.20 The Auto-Negotiation Complete bit is first cleared on a reset, but set shortly after (when
the Auto-Negotiation process is run). Refer to Section 7.3.1, "Virtual PHY Auto-
Negotiation," on page 96 for additional details.
Note 14.21 The Virtual PHY never has remote faults, its link is always up, and does not detect jabber.
Note 14.22 The VIrtual PHY supports basic and some extended register capability. The Virtual PHY
supports Registers 0-6 (per the IEEE 802.3 specification).
6
MF Preamble Suppression
This bit indicates whether the Virtual PHY accepts management frames with
the preamble suppressed.
0: Management frames with preamble suppressed not accepted
1: Management frames with preamble suppressed accepted
RO 0b
5
Auto-Negotiation Complete
This bit indicates the status of the Auto-Negotiation process.
0: Auto-Negotiation process not completed
1: Auto-Negotiation process completed
RO 1b
Note 14.20
4
Remote Fault
This bit indicates if a remote fault condition has been detected.
0: No remote fault condition detected
1: Remote fault condition detected
RO 0b
Note 14.21
3
Auto-Negotiation Ability
This bit indicates the status of the Virtual PHY’s auto-negotiation.
0: Virtual PHY is unable to perform auto-negotiation
1: Virtual PHY is able to perform auto-negotiation
RO 1b
2
Link Status
This bit indicates the status of the link.
0: Link is down
1: Link is up
RO 1b
Note 14.21
1
Jabber Detect
This bit indicates the status of the jabber condition.
0: No jabber condition detected
1: Jabber condition detected
RO 0b
Note 14.21
0
Extended Capability
This bit indicates whether extended register capability is supported.
0: Basic register set capabilities only
1: Extended register set capabilities
RO 1b
Note 14.22
BITS DESCRIPTION TYPE DEFAULT