AMD SC3200 Computer Hardware User Manual


 
AMD Geode™ SC3200 Processor Data Book 45
Signal Definitions
32581C
3.3 Multiplexing Configuration
The tables that follow list multiplexing options and their
configurations. Certain multiplexing options may be chosen
per signal; others are available only for a group of signals.
Where ever a GPIO pin is multiplexed with another func-
tion, there is an optional pull-up resistor on this pin; after
system reset, the pull-up is present. This pull-up resistor
can be disabled by writing Core Logic registers. The config-
uration is without regard to the selected ball function. The
above applies to all pins multiplexed with GPIO, except
GPIO12, GPIO13, and GPIO16.
Table 3-5. Two-Signal/Group Multiplexing
Ball No.
Default Alternate
Signal Configuration Signal Configuration
IDE TFT, PCI, GPIO, System
AD3 IDE_ADDR0 PMR[24] = 0 TFTD3 PMR[24] = 1
AE1 IDE_ADDR1 TFTD2
U2 IDE_ADDR2 TFTD4
AC3 IDE_DATA0 TFTD6
AC1 IDE_DATA1 TFTD16
AC2 IDE_DATA2 TFTD14
AB4 IDE_DATA3 TFTD12
AB1 IDE_DATA4 FP_VDD_ON
AA4 IDE_DATA5 CLK27M
AA3 IDE_DATA6 IRQ9
AA2 IDE_DATA7 INTD#
Y3 IDE_DATA8 GPIO40
Y2 IDE_DATA9 DDC_SDA
Y1 IDE_DATA10 DDC_SCL
W4 IDE_DATA11 GPIO41
W3 IDE_DATA12 TFTD13
V3 IDE_DATA13 TFTD15
V2 IDE_DATA14 TFTD17
V1 IDE_DATA15 TFTD7
Y4 IDE_IOR0# TFTD10
AD1 IDE_IORDY0 TFTD11
AC4 IDE_DREQ0 TFTD8
AD2 IDE_IOW0# TFTD9
AF2 IDE_CS0# TFTD5
P2 IDE_CS1# TFTDE
AD4 IDE_DACK0# TFTD0
AA1 IDE_RST# TFTDCK
AF1 IRQ14 TFTD1
Sub-ISA GPIO
D11 TRDE# PMR[12] = 0 GPIO0 PMR[12] = 1