Filter
Top Products
84 AMD Geode™ LX Processors Data Book
GLIU Register Descriptions
33234H
4.2.4.5 P2D Swiss Cheese Descriptor (P2D_SC)
See Table 4.1.3.1 "Memory Routing and Translation" on page 47 for details on the descriptor usage.
GLIU0 P2D_SC[0]
MSR Address 1000002Ch
Typ e R /W
Reset Value 00000000_00000000h
GLIU1 P2D_SC[0]
MSR Address 4000002Eh
Type R /W
Reset Value 00000000_00000000h
P2D_SC Register Map
63 62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32
PDID1
PCMP_BIZ
RSVD WEN
313029282726252423222120191817161514131211109876543210
REN
RSVD
PSCBASE
P2D_SC Bit Descriptions
Bit Name Description
63:61 PDID1 Descriptor Destination ID 1. These bits define which Port to route the request to, if it is
a ‘hit’ based on the other settings in this register.
000: Port 0 (GLIU0 = GLIU; GLIU1 = GLIU.)
001: Port 1 (GLIU0 = GLMC; GLIU1 = Interface to GLIU0.)
010: Port 2 (GLIU0 = Interface to GLIU1; GLIU1 = VP.)
011: Port 3 (GLIU0 = CPU Core; GLIU1 = GLCP.)
100: Port 4 (GLIU0 = DC; GLIU1 = GLPCI.)
101: Port 5 (GLIU0 = GP; GLIU1 = VIP.)
110: Port 6 (GLIU0 = Not Used; GLIU1 = SB.)
111: Port 7 (GLIU0 = Not Used; GLIU1 = Not Used.)
60 PCMP_BIZ Compare Bizzaro Flag.
0: Consider only transactions whose Bizzaro flag is low as a potentially valid address hit.
A low Bizzaro flag indicates a normal transaction cycle such as a memory or I/O.
1: Consider only transactions whose Bizzaro flag is high as a potentially valid address
hit. A high Bizzaro flag indicates a ‘special’ transaction, such as a PCI Shutdown or
Halt cycle.
59:48 RSVD Reserved.
47:32 WEN Enable hits to the base for the ith 16K page for writes. When set to 1, causes the
incoming request to be routed to the port specified in PDID1 if the incoming request is a
write type.
31:16 REN Enable hits to the base for the ith 16K page for reads. When set to 1, causes the
incoming request to be routed to the port specified in PDID1 if the incoming request is a
read type.
15:14 RSVD Reserved.
13:0 PBASE Physical Memory Address Base for Hit. These bits form the basis of comparison with
incoming checks that the physical address supplied by the device’s request on address
bits [31:18] are equal to PBASE. Bits [17:14] of the physical address are used to choose
the ith 16K region of WEN/REN for a hit.