Filter
Top Products
Brocade Network Advisor IP User Manual 1111
53-1003056-01
Adding a policy monitor
36
a. Select one or more of the following checks in the Available Checks list to include them in
the policy monitor:
For more information about these checks and fixes for rule violations, refer to “Switch and
router policy monitors” on page 1101.
NOTE
The Check for HTTPS (secure HTTP) configuration are not supported on Network OS
products and the following IronWare products: Ethernet Core routers, Ethernet Carrier
Routers, Ethernet Edge router, and Data Center switch, as well as the 6650 Ethernet
switch, router, and L3 router..
NOTE
The Check for Secure SSH (secure Telnet) configuration checks are not supported on the
following IronWare products: Application products running 12.3.X or earlier and the 6910
Ethernet switch.
• Select the Check if the product is configured to send events to this server check to
determine if the Management application server is registered as an SNMP recipient
and Syslog recipient.
• Select the Check for HTTPS (secure HTTP) configuration check to check each target to
see if HTTPS is active for device data transmission.
• Select the Check for SSH (secure Telnet) configuration check to check each target to
see if SSH is enabled for device data transmission.
• Select the Check for SNMPv3 (secure SNMP) configuration check to check each target
to see if SNMPv3 is active for device data transmission and SNMPv1 and SNMPv2 are
not configured.
• Select the Check for VLAN configurations match for each connection (IP only) check to
determine the consistency of VLAN configurations for each connection on the selected
IP devices.
b. Click the right arrow button to move the selected checks to the Selected Checks list.
c. Select the switches or routers to which you want to apply this policy in the Available
Switches/Routers list and click the right arrow button.
NOTE
You can use the All Fabrics targets (under the Product Groups > System Product Groups
node) in the Available Switches/Routers list) for future provisioning. Select All Fabrics and
click the right arrow button to apply this policy to all discovered fabrics.
The selected switches display in the Selected Switches/Routers list.
8. To set policy monitors for hosts, select the Host Checks tab (Figure 461) and complete the
following steps.