Filter
Top Products
Brocade Network Advisor IP User Manual 579
53-1003056-01
Layer 2 access control list management
18
FIGURE 213
Device_Name
- Layer 2 ACL Configuration dialog box
2. Review the Layer 2 ACL configuration details.
• ACLs list — Displays the ACLs to be deployed for this configuration. The ACLs list includes
the following details:
Operation — Displays the ACL operation (no action) during deployment.
Name — The name of the ACL.
Type — The ACL type. Options include: Extended or Standard.
• Details of Selected ACLs list — Displays the details of the ACL selected in the ACLs list. The
Details of Selected ACLs table includes the following details:
Sequence — The Layer 2 ACL entry sequence number.
Action — Whether the ACL permits or denies traffic.
Source — The source MAC address on which the ACL filters traffic.
Destination (Extended only) — The destination MAC address on which the ACL filters
the traffic.
Count — Whether count is enabled or disabled.
Ether Type (Extended only) — The Ethernet protocol. Values include ARP, FCoE, IPv4, or
Custom.
• Add button — Displays; however, is not available.
• Edit button — Displays; however, is not available.
• Duplicate button — Displays; however, is not available.
• Delete button — Displays; however, is not available.
3. Click OK to close on the Device_Name - Layer 2 ACL Configuration dialog box.
Viewing Layer 2 ACL configuration on an interface (Network OS)
NOTE
You cannot configure a Layer 2 ACL using the Management application. You must configure the
Layer 2 ACL through the Network OS CLI (refer to the Network OS Command Reference).
To view Layer 2 ACL configurations on an interface, complete the following steps.