Filter
Top Products
5-50
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
ISSU Upgrade for Redundant Platforms
Step 9
request platform software package install rp
standby-RP file
target-standbyRP-URL-for-sub-packages:asr1000rp*
version*.pkg force
Example:
Router# request platform software package
install rp 1 file
stby-bootflash:asr1000rp*03.13.00.S.154-3.S-ext
*.pkg force
Upgrades the RP subpackages on the standby RP, where the
“rp*” wildcard is specified to capture all of the RP
subpackages for the desired upgrade release.
Step 10
hw-module slot standby-RP reload
Example:
Router# hw-module slot R1 reload
Reloads the standby RP.
Step 11
request platform software package install rp
active-RP file
URL-to-active-file-system:asr1000rp2-{sipbase,sip
spa}*
version*.pkg slot SIP-slot-number force
Example:
Router# request platform software package
install rp 0 file
bootflash:asr1000rp2-{sipbase,sipspa}*03.13.00.
S.154-3.S-ext*.pkg slot 2 force
Upgrades the SIP and SPA subpackages for each SIP on the
router.
Note This step must be completed one SIP at a time, and
repeated for each SIP installed on the router before
performing the next step.
Tip You can use the show ip interface brief command
to identify which slots contain SIPs and SPAs. The
interfaces with three numbers (in the form
SIP-number/SPA-number/interface-number)
identify the SIP and SPA locations in the router.
Note The pattern options used in this CLI (sipbase and
sipspa) were introduced in Cisco IOS XE Release
2.1.2 and are not available in previous Cisco IOS
XE Releases.
See the “ISSU Procedures (Prior to Cisco IOS XE
Release 2.1.2)” section on page 5-72 for pre-Cisco
IOS XE Release 2.1.2 ISSU upgrade procedures.
Command or Action Purpose