Filter
Top Products
5-128
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
Upgrade Process with Service Impact for Nonredundant Platforms
Examples
The following example shows the software upgrade for Cisco ASR 1002 or 1004 Router running
sub-packages:
Router# show version
Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-ADVENTERPRISEK9-M), Version
15.3(2)S, RELEASE SOFTWARE (fc1)
<output removed for brevity>
System image file is "bootflash:Active_Dir/packages.conf"
<output removed for brevity>
cisco ASR1004 (RP2) processor with 1546489K/6147K bytes of memory.
Processor board ID FOX1339G0QJ
32 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
388608K bytes of physical memory.
933311K bytes of eUSB flash at bootflash:.
78085207K bytes of SATA hard disk at harddisk:
Configuration register is 0x2102
Router# show version installed
Package: Provisioning File, version: n/a, status: active
File: bootflash:Active_Dir/packages.conf, on: RP0
Built: n/a, by: n/a
File SHA1 checksum: a624f70f68c60292f4482433f43afd92487a55c4
Package: rpbase, version: 03.12.01.S.154-2.S, status: active
File: bootflash:Active_Dir/asr1000rp2-rpbase.03.12.01.S.154-2.S.pkg, on: RP0
Built: 2013-03-25_18.48, by: mcpre
File SHA1 checksum: 3a9675142898cfac350d4e42f0e37bd9f4e48538
Package: rpcontrol, version: 03.12.01.S.154-2.S, status: active
Step 16
request platform software package install rp 0
file
file-system:asr1000rp*version*.pkg
Example:
Router# request platform software package
install rp 0 file
bootflash:asr1000rp*03.13.00.S.154-3.S-ext*.pkg
Upgrade all subpackages, including the RPBase
subpackage, which is the last subpackage that needs to be
upgraded.
Note This step is required to ensure that all subpackages
on the router were upgraded as part of this
procedure, and might upgrade some subpackages
that would otherwise be missed in the process.
Step 17
show version installed
Example:
Router# show version installed
(Optional) Verify that the subpackages are properly
installed.
Step 18
reload
Example:
Router# reload
Reload the RP.
Tip The router will continue normal operation even
without a reload, so you can reload the router during
scheduled maintenance or a slower traffic period.
Step 19
request platform software package clean
(Optional) Removes the unused subpackages from the
router.
Command or Action Purpose