Filter
Top Products
14-4
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 14 Enabling Support for Tunable DWDM-XFP-C
Configuring the DWDM-XFP-C Module
Configuring the DWDM-XFP-C Module
Perform the following procedure to configure the DWDM-XFP-C module.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface tengigabitethernet slot/port
4. itu channel number
DETAILED STEPS
Verifying the ITU Configuration
The following example shows how to use the show hw-module subslot command to check an ITU
configuration:
Router# enable
Router# conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#int tenGigabitEthernet 1/2/0
Router(config-if)#itu channel 20
Router(config-if)#
Router#
Router# show hw-module subslot 1/2 transceiver 0 idpr dump
Description = XFP optics (type 6)
Transceiver Type: = TUNABLE DWDM XFP (194)
Product Identifier (PID) = DWDM-XFP-C
Frequency Set for Tunable DWDM = 195.5 THz
Command or Action Purpose
Step 1
enable source-interface gigabitethernet
slot/port
Example:
Router# enable
Enables the privileged EXEC mode. If prompted, enter your
password.
Step 2
configure terminal
Example:
Router# configure terminal
Enters the global configuration mode.
Step 3
interface tengigabitethernet slot/port
Router(config)# interface tengigabitethernet
4/11
Specifies the 10-Gigabit Ethernet interface to be
configured.
Here:
slot/port—Specifies the location of the interface.
Step 4
itu channel number
Example:
Router(config-if)# itu channel 28
Sets the ITU channel.
number—Specifies the ITU channel number. The
acceptable values are from 1–82.