Filter
Top Products
2-10
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 2
Getting Help
Router(config-if)# ip ?
Interface IP configuration subcommands:
access-group Specify access control for packets
accounting Enable IP accounting on this interface
address Set the IP address of an interface
authentication authentication subcommands
bandwidth-percent Set EIGRP bandwidth limit
broadcast-address Set the broadcast address of an
interface
cgmp Enable/disable CGMP
directed-broadcast Enable forwarding of directed
broadcasts
dvmrp DVMRP interface commands
hello-interval Configures IP-EIGRP hello interval
helper-address Specify a destination address for UDP
broadcasts
hold-time Configures IP-EIGRP hold time
.
.
.
Router(config-if)# ip
Enter the command that you want to configure for
the interface. This example uses the ip command.
Enter ? to display what you must enter next on the
command line. This example shows only some of
the available interface IP configuration commands.
Router(config-if)# ip address ?
A.B.C.D IP address
negotiated IP Address negotiated over PPP
Router(config-if)# ip address
Enter the command that you want to configure for
the interface. This example uses the ip address
command.
Enter ? to display what you must enter next on the
command line. In this example, you must enter an IP
address or the negotiated keyword.
A carriage return (<cr>) is not displayed; therefore,
you must enter additional keywords or arguments to
complete the command.
Router(config-if)# ip address 172.16.0.1 ?
A.B.C.D IP subnet mask
Router(config-if)# ip address 172.16.0.1
Enter the keyword or argument that you want to use.
This example uses the 172.16.0.1 IP address.
Enter ? to display what you must enter next on the
command line. In this example, you must enter an IP
subnet mask.
A <cr> is not displayed; therefore, you must enter
additional keywords or arguments to complete the
command.
Router(config-if)# ip address 172.16.0.1 255.255.255.0 ?
secondary Make this IP address a secondary
address
<cr>
Router(config-if)# ip address 172.16.0.1 255.255.255.0
Enter the IP subnet mask. This example uses the
255.255.255.0 IP subnet mask.
Enter ? to display what you must enter next on the
command line. In this example, you can enter the
secondary keyword, or you can press Enter.
A <cr> is displayed; you can press Enter to
complete the command, or you can enter another
keyword.
Router(config-if)# ip address 172.16.0.1 255.255.255.0
Router(config-if)#
In this example, Enter is pressed to complete the
command.
Table 2-5 Finding Command Options (continued)
Command Comment