Filter
Top Products
4-6
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 4 Consolidated Packages and SubPackages Management
Managing and Configuring the Router to Run Using Consolidated Packages and Individual SubPackages
A confirm prompt is displayed when the command issu abortversion is issued and when the standby
has not reached the terminal (hot) state.
The following example shows a confirm prompt notification:
The system is without a fully initialized peer and service impact will occur. Proceed with
abort? [confirm]
The issu runversion command is optional for completing a consolidated package upgrade on the
Cisco ASR 1000 Series Routers. You can enter issu commitversion from the active RP to complete the
software upgrade, then use the redundancy force-switchover command to switch to the upgraded RP
on this platform, if desired.
Note For additional information on limited downtime upgrades using the issu command set, see the “Software
Upgrade Processes Supported by Cisco ASR 1000 Series Routers” section on page 5-1.
Managing and Configuring the Router to Run Using Consolidated
Packages and Individual SubPackages
This section discusses the following topics:
• Quick Start Software Upgrade, page 4-6
• Managing and Configuring a Router to Run Using a Consolidated Package, page 4-7
• Managing and Configuring a Router to Run Using Individual SubPackages From a Consolidated
Package, page 4-10
• Managing and Configuring a Router to Run Using Optional SubPackages, page 4-14
• Troubleshooting Software Mismatch with ESP Board ASR1000-ESP10-N, page 4-18
Quick Start Software Upgrade
The following instructions provide a quick start version of upgrading the software running the Cisco
ASR 1000 Series Routers. These instructions assume you have access to the consolidated package and
that the files will be stored in a bootflash: file system that is not storing any previously installed
subpackages or consolidated packages and that has enough room for the file or files.
For more detailed installation examples, see the other sections of this chapter.
To upgrade the software using a quick start version, perform the following steps:
Step 1 Copy the consolidated package into bootflash: using the copy URL-to-image bootflash: command.
Step 2 If you want to run the router using individual subpackages, enter the request platform software
package expand file bootflash:image-name command. If you want to run the router using a
consolidated package, skip this step.
Step 3 Enter the dir bootflash: command to verify your consolidated package or your extracted subpackages
are in the directory.
Step 4 If you are trying to run individual subpackages, use the delete bootdisk:image-name to delete the
consolidated package. If you want to run the router using the consolidated package, skip this step.