Filter
Top Products
5-164
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
Using ISSU to Upgrade the Subpackages in a Dual Route Processor Configuration with MDR
*Mar 14 20:34:38.988: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_REDUNDANCY_STATE_CHANGE(5))
*Mar 14 20:35:47.610: %NBAR_HA-5-NBAR_INFO: NBAR sync DONE!
*Mar 14 20:35:48.023: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
*Mar 14 20:35:49.025: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
Using ISSU to Upgrade the Subpackages in a Dual Route
Processor Configuration with MDR
This section provides instructions on performing an ISSU upgrade on a Cisco ASR 1000 Series Router
with dual RPs that are currently running individual subpackages.
This section covers the following topics:
• Using ISSU to Upgrade the Subpackages on a Cisco ASR 1006 Router or Cisco ASR 1013 Router
(issu Command Set) with MDR, page 5-164
• Using ISSU to Upgrade Subpackages on a Cisco ASR 1006 Router or Cisco ASR 1013 Router
(request platform command set) with MDR, page 5-206
Using ISSU to Upgrade the Subpackages on a Cisco ASR 1006 Router or
Cisco ASR 1013 Router (issu Command Set) with MDR
This section provides the instructions for performing an ISSU upgrade using subpackages with MDR on
a Cisco ASR 1006 router or ASR 1013 router with a dual RP setup using the issu command set.
This procedure can only be performed if the current ASR 1006 or ASR 1013 routers have two active RPs
and both RPs are running subpackages.
SUMMARY STEPS
1. show version
show version active-rp installed
dir filesystem:<directory>
show platform
show redundancy-states
2. copy running-config startup-config
3. mkdir URL-to-directory-name
4. ip tftp source-interface gigabitethernet port
5. copy tftp: URL-to-target-location
6. request platform software package expand file URL-to-consolidated-package
7. dir URL-to-consolidated-package
8. copy file-system:asr1000rp2-espbase.version.pkg URL-to-directory-of-sub-packages-active-RP