Filter
Top Products
19-12
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-15
Chapter 19 Cisco ASR 1000 VxLAN Support
member vni
member vni
To map a virtual network identifier to a bridge domain, use the member vni command in bridge-domain
configuration mode. To remove the VNI from the bridge domain, use the no form of this command.
member vni vni-id
no member vni vni-id
Syntax Description
Command Modes Bridge-domain configuration (config-bdomain)
Command History
Examples
The following example map a virtual network identifier to a bridge domain:
Router(config)# bridge-domain 10
Router(config-bdomain)# member vni 1010
Related Commands
vni-id The VNI number to be mapped to the bridge domain.
Release Modification
Cisco IOS XE Release 3.11S This command was introduced on the Cisco ASR 1000 Series
Routers.
Command Description
member service-instance Binds a bridge domain to the service instance.