Filter
Top Products
5-126
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
Upgrade Process with Service Impact for Nonredundant Platforms
Step 9
request platform software package install rp 0
file
file-system
:asr1000rp2-{rpaccess,rpios,rpcontrol
}*
version-string*.pkg bay standby-bay force
Example:
Router# request platform software package
install rp 0 file
bootflash:asr1000rp2-{rpaccess,rpios,rpcontrol}
*03.13.00.S.154-3.S-ext*.pkg bay 1 force
Upgrade the RPAccess, RPIOS, and RPControl
subpackages in the standby bay.
Step 10
redundancy force-switchover
Example:
Router# redundancy force-switchover
Force a switchover from the active IOS process to the
standby IOS process.
Note Your connection to the router often drops and is
expected behavior at this point of the procedure in
many scenarios.
If this step drops your connection to the router, wait
a few minutes before reconnecting to the router and
then continue to Step 11.
Step 11
(Optional) show platform
Example:
Router# show platform
(Optional) Monitor system state to ensure both IOS
processes are active.
Step 12
request platform software package install rp 0
file
file-system
:asr1000rp2-{rpaccess,rpios,rpcontrol
}*
version-string*.pkg bay standby-bay force
Example:
Router# request platform software package
install rp 0 file
bootflash:asr1000rp2-{rpaccess,rpios,rpcontrol}
*03.13.00.S.154-3.S-ext*.pkg bay 0 force
Upgrade the RPAccess, RPIOS, and RPControl
subpackages in the standby bay, which in this context is the
opposite bay used in Step 9.
Note The pattern options used in this CLI (rpaccess,
rpios, and rpcontrol) were introduced in Cisco IOS
XE Release 2.1.2 and are not available in previous
Cisco IOS XE Releases.
See the “ISSU Procedures (Prior to Cisco IOS XE
Release 2.1.2)” section on page 5-72 for pre-Cisco
IOS XE Release 2.1.2 ISSU upgrade procedures.
Command or Action Purpose