Filter
Top Products
18-5
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 18 LSM-MLDP-based MVPN Support
Step 9
mdt default mpls MLDP root-node
Example:
Router(config-vrf)# mdt default mpls
MLDP 2.2.2.2
Configures MLDP MDT for a VRF. The root node can be
IP address of a loopback or physical interface on any
router (source PE, receiver PE or core router) in the
provider network. The root node address should be
reachable by all the routers in the network. The router
from where the signalling occurs functions as the root
node.
The default MDT must be configured on each PE router
to enable the PE routers to receive multicast traffic for this
particular MVRF.
Note By default MPLS MLDP is enabled. To disable,
use the no mpls MLDP command.
Note LSPVIF tunnel is created as a result of mdt
default mpls MLDP root-node command.
Step 10
mdt data mpls MLDP numberofdataMDTs
Example:
Router(config-vrf)# mdt data mpls MLDP
100
Configures the MLDP data MDP.
Step 11
mdt data threshold bandwidth
Example:
Router(config-vrf)# mdt data threshold
20
Configures the threshold value for data MDT.
Note Bandwidth is traffic rate in Kb/s.
Step 12
exit
Example:
Router(config-vrf)# exit
Exits the configuration session.
Step 13
ip multicast-routing vrf vrf-name
distributed
Example:
Router(config)# ip multicast-routing
vrf blue distributed
Enables multicast routing for the specified VRF.
Step 14
end
Example:
Router(config)# end
Closes the configuration session.
Command Purpose