Filter
Top Products
16-35
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
Note Ethernet-to-EtherChannel over MPLS (Bridge) Interworking mode is also supported under VLAN.
Any-to-EtherChannel over MPLS (Routed) Interworking
You can configure Any-to-EtherChannel over MPLS (Routed) interworking on the Cisco ASR 1000
Series Routers.
Any-to-EtherChannel over MPLS (Routed) interworking supports the following modes:
• ATM-to-EtherChannel
• Ethernet-to-EtherChannel
• PPP-to-EtherChannel
Configure L2VPN interworking on the upstream interfaces of PE routers. For more information about
configuring L2VPN interworking on the PE routers, see L2VPN Interworking Modes, page 16-2.
For information about how to configure ATM on the downstream interfaces of a PE router, see the
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking, page 16-15. Meanwhile,
perform the steps described in the EtherChannel-to-EtherChannel over MPLS (Routed) Interworking,
page 16-30, on the downstream interfaces of the other PE router.
For the Ethernet-to-EtherChannel mode, see the Any-to-EtherChannel over MPLS (Bridged)
Interworking, page 16-33.
For the PPP-to-EtherChannel mode, perform the steps described in the EtherChannel-to-EtherChannel
over MPLS (Routed) Interworking, page 16-30, on the downstream interfaces of the other PE router.
Meanwhile, perform the following steps on the downstream interfaces of the PE routers:
SUMMARY STEPS
1. enable
2. configure terminal
3. (Optional) ipv6 unicast-routing
4. mpls ip default-route
5. mpls ldp graceful-restart
6. xconnect logging pseudowire status
7. controller t1 slot | subslot | port
8. clock source internal
9. linecode b8zs
10. cablelength long db-loss-value
11. channel-group channel-group-number timeslots range
12. exit
13. pseudowire-class pw-class-name
14. encapsulation mpls
15. interworking ethernet
16. exit