![](http://pdfasset.owneriq.net/f/12/f12612a7-fa0f-4123-ba43-1261b31655d3/f12612a7-fa0f-4123-ba43-1261b31655d3-bg50.png)
5-8
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
ISSU Upgrade for Redundant Platforms
DETAILED STEPS
Command or Action Purpose
Step 1
ip tftp source-interface gigabitethernet slot/port
Example:
Router(config)# ip tftp source-interface
gigabitethernet 0
Specifies the Gigabit Ethernet TFTP
source-interface to be configured:
slot/port—Specifies the location of the TFTP
source-interface.
Note To copy a file using TFTP through the
Management Ethernet interface, the ip tftp
source-interface GigabitEthernet 0
command must be entered before entering
the copy tftp command.
Step 2
copy tftp: URL-to-target-location
copy source-file-system:filename
standby-destination-filesystem
Example:
Router# copy tftp bootflash:
Copy the consolidated package onto the active RP.
Step 3
copy source-file-system:filename
standby-destination-filesystem
Example:
Router# copy
bootflash:asr1000rp1-adventerprisek9.02.01.01.122-33.
XNA1.bin stby-bootflash:
Copy the consolidated package onto the standby RP.
Step 4
dir URL-to-target-location
dir
URL-to-target-stby-location
Example:
Router# dir bootflash:
Router# dir stby-bootflash:
(Optional) Display the contents of the target
directories to confirm the successful copy of the file
package.
Step 5
issu loadversion rp upgrade-rp-number
standby-file-system:filename
Example:
Router# issu loadversion rp 1 file
stby-bootflash:asr1000rp1-adventerprisek9.02.01.01.12
2-33.XNA1.bin
Load the target consolidated package onto the
standby RP.
After you receive the message indicating that the
terminal state has been reached, go on to Step 6.