Filter
Top Products
19-16
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-15
Chapter 19 Cisco ASR 1000 VxLAN Support
source-interface loopback
source-interface loopback
To assign a previously created loopback interface to an NVE interface, use the source- interface
loopback command in NVE interface configuration mode. To remove the loopback interface from the
NVE interface, use the no form of this command.
source-interface loopback number
no source-interface loopback number
Syntax Description
Command Modes NVE interface configuration (config-if)
Command History
Examples
The following example maps a loopback interface to an NVE interface:
Router(config)# interface nve 1
Router(config-if)# source-interface loopback 0
Related Commands
Additional References
Related Documents
number The loopback interface assigned to the NVE interface.
Release Modification
Cisco IOS XE Release 3.11S This command was introduced on the Cisco ASR 1000 Series
Routers.
Command Description
interface nve Configures the NVE interface and enters NVE interface
configuration mode.
Related Topic Document Title