Filter
Top Products
3-5
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 3
Configuring Persistent Telnet
Configuring Persistent Telnet
This task describes how to configure persistent Telnet on the Cisco ASR 1000 Series Routers.
Prerequisites
For a persistent Telnet connection to access an IOS vty line on the Cisco ASR 1000 Series Router, local
login authentication must be configured for the vty line (the login command in line configuration mode).
If local login authentication is not configured, users will not be able to access IOS using a Telnet
connection into the Management Ethernet interface with an applied transport map. Diagnostic mode will
still be accessible in this scenario.
SUMMARY STEPS
1. (Required) enable
2. (Required) configure terminal
3. (Required) transport-map type persistent telnet transport-map-name
4. (Required) connection wait [allow {interruptible} | none {disconnect}]
5. (Optional) banner [diagnostic | wait] banner-message
6. (Required) transport interface GigabitEthernet 0
7. (Required) exit
8. (Required) transport type persistent telnet input transport-map-name
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
transport-map type persistent telnet
transport-map-name
Example:
Router(config)# transport-map type persistent
telnet telnethandler
Creates and names a transport map for handling persistent
Telnet connections, and enters transport map configuration
mode.