Filter
Top Products
2-9
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 2
Getting Help
Table 2-5 Finding Command Options
Command Comment
Router> enable
Password: <password>
Router#
Enter the enable command and password to access
privileged EXEC commands. You are in privileged
EXEC mode when the prompt changes to a “
#” from
the “
>”; for example, Router> to Router#.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Enter the configure terminal privileged EXEC
command to enter global configuration mode. You
are in global configuration mode when the prompt
changes to
Router(config)#.
Router(config)# interface serial ?
<0-6> Serial interface number
Router(config)# interface serial 4 ?
/
Router(config)# interface serial 4/ ?
<0-3> Serial interface number
Router(config)# interface serial 4/0 ?
<cr>
Router(config)# interface serial 4/0
Router(config-if)#
Enter interface configuration mode by specifying
the serial interface that you want to configure using
the interface serial global configuration command.
Enter ? to display what you must enter next on the
command line. In this example, you must enter the
serial interface slot number and port number,
separated by a forward slash.
When the <cr> symbol is displayed, you can press
Enter to complete the command.
You are in interface configuration mode when the
prompt changes to
Router(config-if)#.
Router(config-if)# ?
Interface configuration commands:
.
.
.
ip Interface Internet Protocol config
commands
keepalive Enable keepalive
lan-name LAN Name command
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load calculation
for an
interface
locaddr-priority Assign a priority group
logging Configure logging for interface
loopback Configure internal loopback on an
interface
mac-address Manually set interface MAC address
mls mls router sub/interface commands
mpoa MPOA interface configuration commands
mtu Set the interface Maximum Transmission
Unit (MTU)
netbios Use a defined NETBIOS access list or
enable
name-caching
no Negate a command or set its defaults
nrzi-encoding Enable use of NRZI encoding
ntp Configure NTP
.
.
.
Router(config-if)#
Enter ? to display a list of all the interface
configuration commands available for the serial
interface. This example shows only some of the
available interface configuration commands.