Filter
Top Products
16-28
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
Configuring Gigabit EtherChannel for Virtual Private Wire
Service
The GEC VPWS support feature is supported by AToM on the EtherChannel Interface, and includes the
following features:
• EtherChannel-to-EtherChannel over MPLS (Bridged) Interworking, page 16-28
• EtherChannel-to-EtherChannel over MPLS (Routed) Interworking, page 16-30
• Any-to-EtherChannel over MPLS (Bridged) Interworking, page 16-33
• Any-to-EtherChannel over MPLS (Routed) Interworking, page 16-35
EtherChannel-to-EtherChannel over MPLS (Bridged) Interworking
Configure L2VPN interworking on the upstream interfaces of the PE routers. For more information
about configuring L2VPN interworking on the PE routers, see L2VPN Interworking Modes, page 16-2.
After configuring MPLS Forwarding, perform the following steps on the downstream interfaces of the
PE routers:
SUMMARY STEPS
1. enable
2. configure terminal
3. mpls label protocol ldp
4. interface loopback loopback-interface-number
5. ip address ip-address ip-subnet-mask
6. exit
7. pseudowire-class pw-class-name
8. encapsulation mpls
9. interworking ethernet
10. exit
11. interface port-channel number
12. xconnect peer-ip-address vc-id encapsulation mpls pseudowire-class pw-class-name
13. interface GigabitEthernet slot | subslot | port
14. channel-group port-channel number