Filter
Top Products
11-14
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 11 Network Synchronization Support
Configuring Network Synchronization
Configuring SyncE by Using the Line to External Feature
This section describes how to configure network synchronization by using the Line to External feature.
Note The Line to External feature is not supported on the Cisco ASR 1002-X Router.
SUMMARY STEPS
1. configure terminal
2. network-clock synchronization automatic
3. network-clock synchronization ssm option {1 | 2 {GEN1 | GEN2}}
4. interface gigabitethernet slot/card/port
5. synchronous mode
6. exit
7. network-clock output-source line priority {interface interface-name} {external slot/card/port}
8. exit
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
Router# configure terminal
Enters the global configuration mode.
Step 2
network-clock synchronization automatic
Example:
Router(config)# network-clock
synchronization automatic
Enables the network clock selection algorithm. This
command disables the Cisco-specific network clock
process, and turns on the G.781-based automatic clock
selection process.
Step 3
network-clock synchronization ssm
option {1 | 2 {GEN1 | GEN2}}
Example:
Router(config)# network-clock
synchronization ssm option 2 GEN1
Configures the equipment to work in a synchronization
network. The option_id value 1 refers to a
synchronization network design for Europe. This is the
default value. The option_id value 2 refers to a
synchronization network design for the U.S.
Step 4
interface gigabitethernet
slot/card/port
Example:
Router(config)# interface
gigabitethernet 0/2/0
Specifies the Gigabit Ethernet interface to be
configured:
slot/card/port—Specifies the location of the interface.