Filter
Top Products
5-23
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
Figure 5-12 Front Card Extractor Lever
Step 6
Pull the extractor lever(s) to disconnect the front card from the midplane.
Step 7 Gently pull the front card out of the card cage. Keep the front card level and make sure that it does not
hit the one beneath it.
Step 8 Place the front card in an antistatic bag or on an antistatic bench.
Step 9 Repeat Step 5 through Step 8 for each front card that you are removing from the chassis.
Remove the Back Cards
Complete the following steps to remove back cards from the chassis.
Caution Do not use a power screwdriver on captive screws.
Step 1 Record the location of all of the cards before you remove them.
Step 2 Use the flat-head or Phillips tip of the 3-in-1 tool to loosen the two captive screws located on the top and
bottom of the back card faceplate.
Step 3 Pull each of the two extractor levers, located at the top and bottom of the faceplate, out to the horizontal
position.
Step 4 Pull evenly on the two extractor levers to remove the back card from the card cage.
Step 5 Place the back card in an antistatic bag or on an antistatic bench.
Step 6 Repeat Step 2 through Step 5 for each back card that you are removing from the chassis.
Top of card
Slot
H8293