Filter
Top Products
5-43
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
The CP connection can also be set up through a terminal server, as shown in Figure 5-27.
Figure 5-27 Terminal Server Connection to the Console Port
For further information about server management and configuration setup, refer to the appropriate
software configuration guide for your switch and your release.
Connect Power to the MGX 8850 or MGX 8850/B Switch
The section provides the following installation procedures for connecting power to the switch:
• “Connect AC Power to the Switch” section on page 5-44
• “Connect DC Power to the Switch” section on page 5-44
Warning
Never install an AC power module and a DC power module in the same chassis.
Statement 264
Table 5-2 Terminal Settings
Setting Value
Baud rate 9600 bps
Character size 8 data bits
Parity None
Stop bits 1
Hardware flow control None
PXM
UI-S3
C
P
M
P
A
L
1
N
L
2
N
A
L
A
A
R
M
E
X
T
C
L
K
1
E
X
T
C
L
K
2
44371
PXM-UI-S3
back card
Workstation
Terminal server
Serial cable
Serial, LAN,
or dial-up
connection