Filter
Top Products
4-4 Sending Faxes With the MultiPASS C3500 Chapter 4
❍ When the document has been sent successfully, the
display shows these messages.
The MultiPASS automatically redials if the receiving fax does
not answer, if the line is busy, or if a transmission error
occurs. You can specify the number of times it redials using
the Retries option in the Send Fax dialog box of the
MultiPASS Desktop Manager (see page 8-4). If all redial
attempts fail, the MultiPASS beeps intermittently for a few
seconds. If this happens, check the fax number and try
sending the fax again.
If the
ALARM
light is flashing, correct the error described in
the LCD display, and then press
STOP
. You may need to open
the operator panel to remove the document from the ADF
(see page 10-3).
Automatic Dialing
You can send a document using one-touch speed dialing, coded speed
dialing, or group dialing. You must register the one-touch speed dialing
numbers, the coded speed-dialing numbers, and the group dialing
numbers using the MultiPASS Desktop Manager before you can send
documents using these automatic dialing methods. See Setting Up Speed
Dial Assignments on page 8-12.
❍ Place the document face down in the ADF.
DOCUMENT READY
Load the
document.
TX/RX NO. 0001
TRANSMITTING OK