Filter
Top Products
7-9
Cisco ASR 1000 Series Aggregation Services Routers Installation and Initial Configuration Guide
OL-13208-03
Chapter 7 Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Configuring the Cisco ASR 1000 Series Routers at Startup
Note This is only an example of the output display; prompts may vary.
When you see this information, you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2 The first sections of the configuration script appear only at an initial system startup. On subsequent uses
of the setup facility, the script begins with a System Configuration Dialog as shown below: When asked
if you would like to enter the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the
system, extended setup will ask you to configure each interface on the system.
Note Basic management setup configures enough connectivity for managing the system; extended setup will
ask you to configure each interface on the system. For detailed information about setting global
parameters, refer to the Cisco ASR 1000_Series Aggregation Services Routers Software Configuration
Guide.
Checking the Running Configuration Settings
To check the value of the settings you have entered, enter the show running-config command at the
Router#
prompt:
Router# show running-config