Filter
Top Products
2-4
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Chapter 2 Cisco ASR 1000 Series Routers Components
Cisco ASR 1000 Series Route Processor
Table 2-1 lists the Cisco ASR 1000 Series Route Processor LEDs and behaviors.
Table 2-1 Cisco ASR 1000 Series Route Processor LEDs
LED Label LED Color —State Behavior Description
PWR Power Solid green All power requirements are within
specification
Off Off, the router is in standby mode.
STAT System status Solid green Cisco IOS software has successfully
booted.
Yellow BootROM has successfully loaded.
Red System failure or during boot process.
ACTV Active Green Lit when the Cisco ASR 1000 Series RP1
is active.
STBY Standby Yellow Lit when the Cisco ASR1000 Series RP1 is
the standby processor.
CRIT Critical Solid Red Critical alarm indicator or during boot
process. An example: the ambient air tem-
perature is above 60ºC and will begin
shutdown in 5 minutes.
MAJ Major Solid Red Major alarm indicator. For example:
Ambient air temperature is beyond short
term operating range of 55ºC. System will
shut down above 60ºC.
MIN Minor Amber Minor alarm indicator. Ambient air tem-
perature is beyond normal operating range
of 40ºC. For example: if the RP software
determines that an unknown card has been
installed or if the card has failed, the card
can power it off or set a minor alarm.
DISK HD Internal hard drive
LED
Flashing Green Activity indicator.
Off No activity.
DISK USB External USB Flash
LED
Flashing Green Activity indicator.
Off No activity.
DISK BF Internal USB
bootflash LED
Flashing Green Activity indicator.
Off No activity.
CARRIER LED Off Out of service or not configured.
Solid Green In frame and working properly.
Amber Fault or loop condition exists.
LINK 10/100/1000 RJ-45
Interface LED
Solid Green Link with no activity.
Flashing Green Link with Activity.
Off No link.