Filter
Top Products
8-16
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units
Removing and Replacing the 1GB USB Flash Token Memory Stick
Figure 8-13 shows the USB port 0 or 1 connector (callout 4) on the Cisco ASR 1000 Series Route
Processor 1 for the 1GB flash token memory stick.
Figure 8-13 Cisco ASR 1000 Series Route Processor 1 Token Memory Stick Port
Caution Do not remove a USB Flash memory module when issuing some file access command or a read/write
operation to the Flash memory module when it is processing. The router might reload or the USB Flash
memory module can be damaged. You can check to see if the USB activity LED on the Cisco ASR1006
or ASR1004 router RP1 front panel is flashing, prior to the removal of the USB device (does not apply
to the Cisco ASR1002 Router).
To remove and then replace a USB 1GB flash token memory stick, follow these steps:
Step 1 Pull the memory stick from the USB port.
Note The Cisco ASR 1002 Router has only one USB port.
Step 2 To replace a Cisco USB Flash memory stick, simply insert the module into the USB port 0 or 1 port as
shown in
Figure 8-14. The Flash memory module can be inserted in only one way, and can be inserted
or removed regardless of whether the router is powered up or not.
Note Figure 8-12 is only a sample of how the memory stick is inserted into the port and does not
display the Cisco ASR 1000 RP1 face-plate.
1 Internal hard drive LED 4 USB0 and USB1 connectors
2 External USB Flash LED 5 Cisco ASR1000-RP1 LEDs
3 Internal USB bootflash LED
01
DISK
BF
USB
HD
MIN
ACO
MAJ
STBY
ACTV
STAT
ASR1000-RP1
PWR
CRIT
280078
5
4
1
2
3