Filter
Top Products
7-10
Cisco ASR 1000 Series Aggregation Services Routers Installation and Initial Configuration Guide
OL-13208-03
Chapter 7 Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Power Off the Cisco ASR 1000 Series Router
To review changes you make to the configuration, use the EXEC mode show startup-config command
to see the changes and copy run-start stored in NVRAM.
Saving the Running Configuration to NVRAM
To store the configuration or changes to your startup configuration in NVRAM, enter the copy
running-config startup-config command at the Router# prompt:
Router# copy running-config startup-config
Using this command saves the configuration settings that you created in the router using configuration
mode and the setup facility. If you fail to do this, your configuration will be lost the next time you reload
the router.
Power Off the Cisco ASR 1000 Series Router
This section explains how to shut down the Cisco ASR 1000 Series router. It is recommended that before
turning off all power to the chassis, you issue the reload command. This insures that the operating
system cleans up all the file systems. Once the reload operation is complete, then the Cisco ASR 1000
Series router can be powered off safely.
To remove power from the Cisco ASR 1000 Series Router, follow this procedure:
Step 1 Slip on the ESD-preventative wrist strap that was included in the accessory kit.
Step 2 Before you shutdown a power supply, issue the IOS reload command to halt the system and then wait
for ROM Monitor to execute before proceeding to the next step. The following screen shot shows an
example of the reload command:
Router#reload
Proceed with reload? [confirm]
*Jun 18 19:38:21.870: %SYS-5-RELOAD: Reload requested by console. Reload Reason:
Reload command.
Step 3 Remove any power cables from the Cisco ASR 1000 Series Router.
a. For power supplies with a circuit breaker switch, position the switch to the Off (O) position.
b. For power supplies with a Standby switch, place the Standby switch in the Standby position.
Note After powering off the router, wait a minimum of 30 seconds before powering it on again.