Filter
Top Products
4-22 Service Tests
HP DesignJet CP Series Printers
In these cases, try one of the following:
1 Check that the cable for the Refill Valve Sensors is connected correctly.
2 Check that the Refill interconnect cable is connected correctly.
3 Replace the Refill Assembly ' page 8-55.
Standby Button Sensor Failure
If there is a problem with the Standby Button Sensor then the following
message will appear:
D “D0808 Fail” - Standby Button Sensor failed.
In this case, try one of the following:
1 Check that the cable for the Standby Button Sensor is connected
correctly.
2 Replace the Standby Button Assembly ' page 8-24.
Media Sensor Failure
If there is a problem with the Media Sensor then the following message will
appear:
D “D0809 Fail” - Media Sensor failed.
In this case, try one of the following:
1 Check that the cable for the Media Sensor is connected correctly.
2 Replace the Media Sensor Assembly ' page 8-78.
Pincharm Sensor Failure
If there is a problem with the Pincharm Sensor then the following message
will appear:
D “D0810 Fail” - Pincharm Sensor failed.
In this case, try one of the following:
1 Check that the cable for the Pincharm Sensor is connected correctly.
2 Replace the Pincharm Sensor Assembly ' page 8-84.