Filter
Top Products
8-60 Removal and Installation
HP DesignJet CP Series Printers
Starguard Assembly
Refer to figure 21 ' page 8-61
WARNING
Switch off the printer and remove the power cord.
Removal
1. Remove the following:
1. Window and Top Cover ' page 8-15.
2. Left Hand Cover ' page 8-18.
3. Right Hand Cover ' page 8-21.
4. Refill Assembly ' page 8-55
2. Remove the two T-20 screws (item 1) securing the starguard assembly
(item 2) to the right hand side chassis.
3. Remove the two T-20 screw securing the starguard assembly to the left
hand side chassis.
4. Slide out the starguard assembly.
Installation
1. Install the starguard assembly into the correct position in the printer.
2. Install the two T-20 screws (item 1) securing the starguard assembly
(item 2) to the right hand side chassis.
3. Install two T-20 screw securing the starguard assembly to the left hand
side chassis.
4. Install the following:
1. Refill Assembly ' page 8-55
2. Right Hand Cover ' page 8-21.
3. Left Hand Cover ' page 8-18.
4. Window and Top Cover ' page 8-15.
5. Connect the power cord.