Filter
Top Products
4-8 Service Tests
HP DesignJet CP Series Printers
Electronics Failure
If there is a problem with the components within the Electronics module
then the following messages will appear.
D “D0101 Fail” - The Swath RAM has failed.
D “D0102 Fail” - The Writing System and Printhead control ASIC rotator
failed.
D “D0103 Fail” - The EEROM is corrupted.
In these cases, Replace the Electronics Module ' page 8-6.
Hard Disk Failure
If there is a problem with the Hard Disk then the following message will
appear.
D “D0104 Fail” - The Hard Disk has failed.
In this case, try one of the following:
1 If the Error Code appears again then check that the Hard Disk data
cable is correctly connected at both ends. Also check that the Hard
Disk Power Cable is correctly connected.
2 Replace the Hard Disk data cable ' page 8-12.
3 If the Error Code continues to appear, then replace the Hard Disk '
page 8-12.
Line Sensor Failure
If there is a problem with the Line Sensor then the following message will
appear.
D “D0105 Fail” - The Line Sensor presence test failed.
In this case, try one of the following:
1 Check if the Line Sensor is installed and connected correctly.
2 Check and if necessary replace the Trailing Cable ' page 8-36.
3 Replace the Carriage Assembly ' page 8-42.
Only replace one component at a time and perform the test again
before replacing another component. Using this procedure you
will be able to determine exactly which component failed.
The test is continued on the next page.