Filter
Top Products
4-4 Service Tests
HP DesignJet CP Series Printers
8 Sensors ' page 4-20
The purpose of this test is to verify the operation of the following
Sensors:
D Window Sensor.
D Right Door Sensor.
D Left Door Sensor.
D Refill Valve Sensors.
D Standby Button Sensor.
D Media Sensor.
D Pincharm Sensor.
9 MIO Presence ' page 4-23
The purpose of this test is to verify the presence of the MIO Card and the
communication between the MIO Card and Main PCA.
10 Cutter ' page 4-24
The purpose of this test is to verify the operation of the cutter Assembly.
11 Bail ' page 4-25
The purpose of this test is to verify the operation of the bail stepper
motor.
12 Image Quality ' page 4-26
The purpose of this test is to verify the image quality attributes of the
printer.
13 Printhead ID ' page 4-28
The purpose of this test is to check the printhead ID.
14 Printhead Continuity ' page 4-29
The purpose of this test is to display the primitives and address maps of
the printheads.
15 Clean Roller ' page 4-31
The purpose of this test is to enable you to rotate the Drive Roller when
it requires cleaning.
16 Erase EEROM ' page 4-32
The purpose of this test is to clear the EEROM.
17 Reset Counters ' page 4-33
The purpose of this test is to reset the internal counters.
18 Not Applicable
19 Hard Disk Drive Revision ' page 4-34