Filter
Top Products
Removal and Installation
8-53
HP DesignJet CP Series Printers
Installation
Note: At the same time as performing step one, install loose
cables into the cable clamp, which is located on the left hand
side chassis.
1. Install the elevator assembly onto the three loosened T-20 screws (item
2). Tighten the three screws.
2. Install the T-20 screw (item 1) into the bottom rear of the elevator
assembly.
3. Connect the platform sensor cable in position J5 PLATEF SENSOR on
the refill interconnect PCA.
4. Connect the elevator stepper motor cable in position J9 ELEV
STEPPER on the refill interconnect PCA.
5. Install the top half of the elevator assembly by securing it to two
retaining clips at the back and push down and to the right.
6. Install the following:
1. Left Hand Cover ' page 8-18.
2. Window and Top Cover ' page 8-15.
7. Install the ink delivery system (Refer to the User Guide).
8. Install the power cable and turn the printer on in service mode.
9. Perform D06 Refill Service Test ' page 4-18