Filter
Top Products
8-58 Removal and Installation
HP DesignJet CP Series Printers
Bail Assembly and Star Wheel Assemblies
Refer to figure 20 ' page 8-59
Removal
1. Open the window.
2. Manually move the carriage assembly to the left side of the printer.
3. Lifting up the bail assembly (item 1), push both the plastic arms at the
end of the bail assembly together. This will release it from holes in the
left and right hand side chassis.
4. Remove the right side of the bail arm first and then the left.
Note: If the mark encoder which is glued to the drive roller obstructs
the removal of the bail assembly, press Form Feed and Cut this will
move the drive roller around.
5. Remove the star wheel assemblies (item 2) by pushing together the
retaining clips and pulling them off
Installation
1. Install the star wheel assemblies (item 2) by pushing the retaining clips
into the bail assembly (item 1).
2. Install the bail assembly by installing the left side first, then install the
bail assembly into holes in the left and right hand side chassis.
3. Close the window.
4. Perform D11 Bail Service Test ' page 4-25