Filter
Top Products
8-29 Removal and InstallationHP DesignJet CP Series Printers
Primer Assembly (Only Applicable to
HP DesignJets 2500CP/2000CP)
NOTE FOR HP DESIGNJETS 3500CP/3000CP: IF THE
PRIMER ASSEMBLY FAILS, YOU MUST REPLACE THE
COMPLETE SERVICE STATION.
Refer to figure 9 ' page 8-31
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Window and Top Cover ' page 8-15.
2. Right Hand Cover ' page 8-21.
2. Manually slide the carriage assembly to the middle of the printer.
3. Disconnect the 4 tubes (item 1) from the primer assembly (item 3).
4. Release the cables from the cable clamp located underneath the service
station assembly.
5. Remove the service station interconnect PCA from underneath the
service station assembly by releasing it from a retaining clip and sliding
it out.
6. Disconnect the primer stepper cable from position J8 PRIMER
STEPPER on the service station interconnect PCA.
7. Disconnect the primer sensor cable from the position J4 PRIMER
SENSOR on the service station interconnect PCA.
8. Remove the three T-15 screws (item 2) securing the Primer Assembly
(item 3) to the service station assembly (item 4).
9. Remove the primer assembly.