Filter
Top Products
Removal and Installation
8-85
HP DesignJet CP Series Printers
Installation of the pincharm sensor.
1. Install the pincharm sensor into the correct position and secure with two
T-10 screws (item 1).
2. Install the pincharm sensor cable into the cable clamp (item 2) secured
to the left hand side chassis.
3. Connect the pincharm sensor cable to the electronics module in position
J8 PINCH.
4. Install the following:
1. Right Hand Cover ' page 8-21.
2. Service Station Assembly ' page 8-26
5. Connect the power cord and turn the printer on in service mode.
6. Perform D08 Sensor Service Test ' page 4-31
Installation of the pincharm assemblies and the pincharm shaft.
1. Install the pincharm shaft (item 6) into the left hand side chassis and at
the same time install the pincharm spring (item 8) and pincharm
assemblies (item 7) into the plastic bushing (item 9) in the chassis.
2. Install the cam journal (item 4) onto the pincharm shaft on the right
hand side chassis.
3. Making sure that you do not over tighten the screw, secure the cam
journal on the end of the pincharm shaft with the T-9 screw (item 3).
4. Install the top half of the elevator assembly by securing it to two
retaining clips at the back and push down and to the right.
5. Install the following:
1. Overdrive Assembly and Drive Roller ' page 8-69.
2. Service Station Assembly ' page 8-26.
3. Left Hand Cover ' page 8-18.
4. Right Hand Cover ' page 8-21.
5. Window and Top Cover ' page 8-15.
6. Connect the power cord and turn the printer on in service mode.
7. Perform D08 Sensor Service Test ' page 4-31