Filter
Top Products
8-62 Removal and Installation
HP DesignJet CP Series Printers
Bail Stepper Motor
Refer to figure 22 ' page 8-63
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Left Hand Cover ' page 8-18.
2. Bail Arm Assembly ' page 8-58
2. Remove the top half of the elevator assembly by releasing it from two
retaining clips at the back and lifting up and to the left.
3. Disconnect the bail stepper motor cable (item 1) from position J7
STEPPER MOTOR on the refill interconnect PCA (item 2).
4. Release the bail stepper motor cable from the cable clamp (item 3) on the
left hand side chassis.
5. Remove the bail stepper motor (item 5) by removing two T-10 screws
(item 4).
Installation
1. Install the bail stepper motor (item 5) in the correct position on the left
hand side chassis.
2. Install two T-10 screws (item 4) into the left hand side chassis securing
the bail stepper motor.
3. Connect the bail stepper motor cable (item 1) to the refill interconnect
PCA (item 2) in position J7 STEPPER MOTOR.
4. Install the bail stepper motor cables into a cable clamp (item 3) on the
left hand side chassis.
5. Install the top half of the elevator assembly by securing it to two
retaining clips at the back and push down and to the right.
6. Install the following:
1. Left Hand Cover ' page 8-18.
2. Bail Arm Assembly ' page 8-58
7. Connect the power cord and turn the printer on in service mode.
8. Perform D11 Bail Service Test ' page 4-25