Filter
Top Products
8-26 Removal and Installation
HP DesignJet CP Series Printers
Service Station Assembly and Service Station Flag
Refer to figure 8 ' page 8-28
Removal of the Service Station Assembly
1. Remove the ink delivery system (Refer to the User Guide).
WARNING
Switch off the printer and remove the power cord.
2. Remove the following
1. Window and Top Cover ' page 8-15.
2. Right Hand Cover ' page 8-21.
3. Manually slide the carriage assembly to the middle of the printer.
4. Carefully disconnect the black service station interconnect cable
(item 1) from the service station interconnect PCA, this is located under
the service station assembly.
Note for HP DesignJets 3500CP/3000CP: Make sure you
disconnect the Media Button Cable (Item 10) from the Service
Station Interconnect PCA.
5. To remove a T20 screw (item 3) it may be necessary to move the head
cleaner holders to the rear. This can be done by turning the service
station motor gear (item 2), the screw can then be reached by a screw
driver.
6. Loosen the remaining three T-20 screws (item 4) securing the service
station to the printer. These screws are long and can be fully loosened.
7. Remove the service station assembly (item 5) by lifting up and pulling
towards you.
Removal of the Service Station Flag.
1. Release the spring (item 6) from the service station flag (item 7).
2. Position the flag horizontal and push down and to the right
Note: To remove the primer assembly from the service station
assembly, refer to the primer removal procedure ' page 8-29.