Filter
Top Products
5-16 Service Calibrations
HP DesignJet CP Series Printers
C07. Color Calib. (Only available in DesignJet 2500CP/3500CP printer)
The purpose of this calibration is to determine a correction function to be
applied in PostScript in order to match the color reproduction of a nominal
Printer. This Calibration is necessary to improve color consistency between
different prints and different Printers. This calibration is also independent
of color accuracy or matching color from a monitor to the Printer.
Perform the Color calibration whenever:
D Carriage is disassembled or replaced.
D There is a color consistency problem between prints.
D Refill Assembly is disassembled or replaced.
D Electronics Module is replaced.
Load media before performing this test.
Perform the Color Calibration as follows:
MAKE SURE THAT THE WINDOW IS CLOSED BEFORE YOU
PERFORM THIS CALIBRATION.
1 In the Calibrations submenu, scroll to “C7 Color Calib.” and press Enter.
Calibrations
C7 Color Calib.
2 If media is not loaded the calibration will stop and the message “Load
Media” will be displayed on the front-panel. Load media in order to
continue the calibration.
3 While the Calibration is being performed, the message “Calibrating
Color” will be displayed on the front-panel.
4 If the calibration is performed correctly, the “C0700 Done” message is
displayed on the front-panel.
5 If the calibration fails, the “C0701 Fail” message is displayed on the
front-panel.
If the calibrations fails, to resolve the problem, try one of the following:
1 If the calibration pattern is bad:
D Try recovering the printheads using the front-panel menu and try
the calibration again.
D If the calibration pattern is bad again, then replace the complete
Ink Delivery System of the color that is bad.
2 Perform the Electronics Test ' page 4-7.
3 Perform the Line Sensor Test ' page 4-10.