Filter
Top Products
8-8 Removal and Installation
HP DesignJet CP Series Printers
3. X-encoder cable in J1
4. Service station cable in J11
5. Refill station cable in J4
6. Media sensor cable in J6
7. Pinch wheel sensor cable in J8
8. X-motor cable in J7
9. Trailing cable in J3, J5 and J10
7. Install the left and right hand back covers (items 7 and 8).
8. Connect the power cord and turn the printer on in service mode.
9. If a new electronics module is being installed, perform the following
service calibrations:
1. C01 Carriage ' page 5-7
2. C02 Refill ' page 5-9
3. C03 Line Sensor ' page 5-10
4. C10 Font Type Set ' page 5-20
5. C05 Printheads Alignment ' page 5-13
6. C06 Printheads Check ' page 5-14
7. C07 Color Calibration Only for HP DesignJet 2500CP/3500CP
printer ' page 5-16
8. C08 Service Accuracy ' page 5-17
9. C09 Maintenance ' page 5-19 (Adjust Counter)
10. C10 Font Type Set ' page 5-20 (Only for Asian Fonts)
10. Perform the D01 Electronics service test ' page 4-7.