Filter
Top Products
8-36 Removal and Installation
HP DesignJet CP Series Printers
Trailing Cable
Refer to figure 12 ' page 8-38
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Electronics Module ' page 8-6.
2. Window and Top Cover ' page 8-15
3. Right Hand Cover ' page 8-21
2. Manually slide the carriage assembly to the center of the printer.
3. Carefully disconnect the trailing cable (item 1) from connectors on the
carriage PCA.
4. Remove the trailing cable from the trailing cable carriage clamp (item 2).
5. Remove the trailing cable from the trailing cable holder (item 3).
6. Pull the trailing cable through a hole in the Y-axis assembly (item 4).
7. Pull the trailing cable through a hole in the electronics support frame
(item 5).
8. Remove the trailing cable from the 3 cable clamps at the rear of the
printer (item 6).
9. Disconnect the trailing cable from the following positions in the
electronics module:
1. J3 MISC
2. J5 DATA
3. J10 SUPPLY
10.Remove the trailing cable by pulling it through the ferrite (item 7) at the
rear of the printer.