Filter
Top Products
8-30 Removal and Installation
HP DesignJet CP Series Printers
Installation
1. Install the primer assembly (item 3) into the correct position in the
service station assembly (item 4), making sure no cables are trapped
between the two assemblies.
2. Install three T-15 screws (item 2) securing the primer to the service
station assembly.
3. Connect the primer sensor cable to the position J4 on the service station
interconnect PCA.
4. Connect the primer stepper cable to the position J8 to the service station
interconnect PCA.
5. Route the cables through the cable clamps on the underside of the
service station assembly.
6. Holding the retaining clip up, slide the service station interconnect PCA
into place underneath the service station assembly.
7. Connect the 4 tubes (item 1) to the primer assembly, making sure that
the tubes are correctly connected to the corresponding colour on the head
cleaner.
8. Install the following:
1. Right Hand Cover ' page 8-21.
2. Window and Top Cover ' page 8-15.
9. Install the power cable.